Toyota Corolla (E120): Open in p/t squib (lh) circuit

Dtc b0136/74 open in p/t squib (lh) circuit

Share this page:

Other materials:

Electronic control
Removal and installation of battery terminal  before performing electrical work, disconnect the battery negative (–) terminal cable beforehand so as to prevent burnt–out damage by short.  When disconnecting and installing the terminal cable, turn the ignition switch an ...

On–vehicle inspection
1. Inspect drive belt Visually check the belt for excessive wear, frayed cords, etc. If any defect is found, replace the drive belt. Hint: cracks on the rib side of a belt are considered acceptable. If the missing chunks from the ribs are found on the belt, it should be replaced. 2 ...

Overhaul
Hint: overhaul the rh side by the same procedures with lh side. 1. Remove rear wheel 2. Drain brake fluid Notice: wash the brake fluid off immediately if it comes into contact with any painted surface. 3. Remove rear brake drum sub–assy Release the parking brake lever, and remove t ...