Toyota Corolla (E120) 2002–2008 Repair Manual / Wiper & washer / Wiper and washer system / On–vehicle inspection
Toyota Corolla (E120): On–vehicle inspection
1. Washer motor

- Operation check
- pour the water into the washer jar with the washer motor and the pump installed to the washer jar assy.
- Connect the battery (+) to terminal 2 of the washer motor and the pump, the battery (–) to terminal 1 of the washer motor and the pump. Check that the water comes out from the washer jar.
Other materials:
Setting the tire pressure
(vehicles with a tire pressure
warning system)
In the following situations, it will
be necessary to perform the tire
inflation pressure setting procedure
of the tire pressure warning
system.
When the specified tire inflation
pressure has changed,
such as due to carried load,
etc.
When the tire inflation pressure
is changed such as
when t ...
Inspection procedure
1 Check courtesy lamp switch
Check the courtesy switch, as shown in the illustration
and table.
Standard:
2 Check wire harness (integration relay door courtesy sw)
Disconnect the integration relay and door courtesy connectors.
check the continuity between th ...
Initialization
1. Reset memory
Caution:
perform the reset memory (at initialization) when replacing the automatic
transaxle assy, engine
assy or ecm.
Notice:
hand–held tester only
Turn the ignition switch off.
connect the hand–held tester to the dlc3.
turn the ignition switch to th ...


