Toyota Tacoma manuals

Toyota Corolla Repair Manual: On–vehicle inspection

1. Inspect sliding roof function

  1.  check the slide opening operation (manual).
  1.  Turn the ignition switch on.
  2.  When keeping operating the sliding roof switch to the open side, check that the roof glass will slide and be fully opened.
  1.  check the slide closing operation (manual).
  1.  Turn the ignition switch on.
  2.  When keeping operating the slide roof switch to close side, check that the roof glass will slide but stop halfway.
  3.  When operating the sliding roof switch to the close side again after the above operation, check that the roof glass will slide again from the halfway position and be fully closed.

2. Inspect sliding roof drive gear

  1. Disconnect the connector from the relay and switch, and inspect the connector on the wire harness side, as shown in the chart.

* Exceptions:

* Exceptions:

For 60 seconds after the ignition switch on off (acc) or until the driver or passenger door is opened after the ignition switch on off (acc).

If the result is not as specified, replace the relay.

Problem symptoms table

Inspection

Location
...

Inspection
1. Inspect sliding roof limit switch Inspect the sliding roof limit switch continuity. Standard: If the continuity is not as specified, replace the switch. 2. Inspect sliding roof dri ...

Other materials:

Circuit description
The vehicle equipped with abs detects a vehicle speed using the stability control ecu and wheel speed sensor. This sensor monitors a wheel rotation speed and sends the signal to the ecu. The stability control ecu converts these wheel speed signals into a 4–pulse signal and outputs it to th ...

Taking out the spare tire
1 Remove the luggage floor cover. 2 Remove the tool tray. 3 Loosen the center fastener that secures the spare tire. CAUTION ■When storing the spare tire Be careful not to catch fingers or other body parts between the spare tire and the body of the vehicle. ...

On–vehicle inspection
1. Inspect turn signal flasher relay circuit Disconnect the connector from the turn signal flasher relay and inspect the connector on wire harness side as shown in the chart. Standard: Connect the connector to the turn signal flasher and inspect the wire harness side connector ...

© 2011-2023 Copyright www.tcorolla.net