Toyota Corolla (E170): Maintenance data (fuel, oil level, etc.)

Share this page:

Other materials:

Roof drip side finish moulding center lh
Replacement Hint: use the same procedures for the rh side and lh side. The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included. 1. Remove roof drip side finish moulding center lh ...

Overhaul
1. Remove control shift lever bush Remove the control shift lever bush from the selecting bellcrank assy. 2. Remove selecting bellcrank dust cover no.1 Remove the selecting bellcrank dust cover no.1 From the selecting bellcrank assy. 3. Remove selecting bell crank no.2 ...

Inspection procedure
1 Inspect dlc3 terminal voltage(ts terminal) Turn the ignition switch to on. measure voltage between terminals ts and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector between ...