Toyota Corolla (E170): List screen operation

When a list screen is displayed, use the appropriate buttons to scroll through the list.

Share this page:

Other materials:

Dtc check/clear
Notice: if there is no dtc in the normal mode, check the pending fault code using the continuous test results function (mode 7 for sae j1979) on the obd ii scan tool or the hand–held tester. Hand–held tester only: when the diagnosis system is switched from the normal mode to the ...

Front suspension
Service data *1: Ground clearance of front wheel center *2: ground clearance of lower suspension arm front bolt center *3: ground clearance of axle beam set bolt center *4: ground clearance of rear wheel center Torque specification ...

Inspection procedure
1 Check wire harness(dlc3 – airbag sensor assy center) Turn the ignition switch to the lock position.  disconnect the aribag sensor assy center connector.  measure the resistance according to the value(s) in the table below. Standard: 2 Check wire harness(cg of dl ...