Toyota Corolla (E120): Ignition

Lubricant

Recomended tools

Equipment

Equipment

Starting & charging

    Share this page:

    Other materials:

    Oxygen sensor monitor (front and rear o2s system)
    Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...

    Terminals of ecu
    Oscilloscope wave (*1) Hint: terminal: od – gnd gauge set: 5 v / div, 50 ms / div condition: during cruise control driving o/d switch on. ...

    Replacement
    Hint: components: 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Disconnect skid control sensor wire (w/ abs) 4. Remove rear axle hub & bearing assy lh Remove the 4 bolts and hub & bearing assy lh. 5. Install rear axle hub & bearing assy lh Install t ...