Toyota Corolla (E120): Heater & air conditioner

Preparation

Sst

Recomended tools

Recomended tools

Equipment

Equipment

Lubricant

Lubricant

Supplemental restraint system

    Share this page:

    Other materials:

    On–vehicle inspection
    1. Inspect brake booster Airtightness check.  Start the engine and stop it after 1 or 2 minutes. Depress the brake pedal several times slowly. Hint: if the pedal goes down farthest at the 1st time, but gradually rises after the 2nd or 3rd time, the booster is airtight. ...

    Inspection procedure
    Hint: if dtcs p0115, p0116, p0117, p0118 and p0125 are output simultaneously, the engine coolant temperature sensor circuit may be open or short. Perform the troubleshooting of dtc p0115, p0117 or p0118 first. Read freeze frame data using the hand-held tester or the obd ii scan to ...

    Inspection procedure
    1 Check d squib circuit(airbag sensor assy center – horn button assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connector between the airbag sensor assy center and the horn button assy.  for the black ...