Toyota Corolla (E210): Multi-information display (7-inch display)

Share this page:

Other materials:

Inspection procedure
1 Inspect dlc3 terminal voltage(tc terminal) Turn the ignition switch to on.  measure voltage between terminals tc and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector betw ...

Basic inspection
Resistance measuring condition of electronic parts  unless stated, all resistance is measured at an ambient temperature of 20 c (68 °F). As the resistance may be outside the specifications if measured at high temperatures immediately after the vehicle has been running, measu ...

Hydraulic test
1. Perform hydraulic test Measure the line pressure. Notice: Do the test at normal operation atf temperature 50 to 80 °c (122 to 176 °f). The line pressure test should always be carried out in pairs. One technician should observe the conditions of wheels or wheel stopper outsi ...