Toyota Corolla (E120): Front suspension system

Share this page:

Other materials:

Overhaul
1. Drain clutch fluid 2. Remove brake master cylinder sub–assy 3. Remove brake booster assy 4. Disconnect clutch reservoir tube Loosen the clip and disconnect the clutch reservoir tube from the clutch master cylinder assy. Hint: use a container to catch the fluid. 5. Disconnect ...

Body panel undercoating areas
Apply pastar uwe or pastar uc to the chassis, floor underside, sheet metal fitting weld points of the body, and inside of the wheel house to prevent rust and noise, as well as protect the body from flying rocks. Hint:  work must be performed while wearing the appropriate protective ...

Skid control sensor
Replacement Hint: replace the rh side by the same procedure as the lh side. 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Disconnect skid control sensor wire Disconnect the skid control sensor wire connector from the skid control sensor. 4. Remove rear axle hub & ...