Toyota Corolla (E120) 2002–2008 Repair Manual / Drive shaft / propeller shaft / Front axle lh hub bolt
Toyota Corolla (E120): Front axle lh hub bolt
Replacement
Hint
: components:
1. Remove front wheel
2. Separate front disc brake caliper assy lh
3. Remove front disc
4. Remove front axle lh hub bolt

- Using sst and a hammer handle or an equivalent, remove
the lh hub bolt.
Sst 09628–10011
5. Install front axle lh hub bolt

- Install a washer and nut to a new lh hub bolt as shown in the illustllation.
- using a hammer handle or an equivalent to hold the hub sub–assy lh, install the lh hub bolt by tightening the nut.
6. Install front disc
7. Install front disc brake caliper assy lh
8. Install front wheel
torque: 103 nvm (1,050 Kgf·cm, 76 ft·lbf)
Other materials:
Unlocking and locking the doors from the outside
◆ Smart key system (if equipped)
Carry the electronic key to enable this function.
1 Grip the driver’s door handle to unlock the door. Grip the passenger’s door
handle to unlock all the doors.* Make sure to touch the sensor on the back of the
handle.
The doors cannot be unlocked for ...
Terminals of ecu
1. Inspect integration relay
Disconnect the connector from the integration relay.
check the continuity between each terminal of the disconnected connector
and the body ground, as
shown in the illustration and table.
Standard:
If the result is not as specified, the vehicle’s ...
Power outlet
Please use as a power supply for electronic goods that use less than 12 VDC/10
A (power consumption of 120 W).
Open the lid.
■The power outlet can be used when
► Vehicles without a smart key system
The engine switch is in the “ACC” or “ON” position.
► Vehicles with ...


