Toyota Corolla (E120): Ecu power source circuit

Share this page:

Other materials:

Malfunction in water temperature receiver gauge
Wiring diagram Inspection procedure 1 Read value of hand–held tester Check output value of ecm.  Connect the hand–held tester to dlc3.  Turn the ignition switch to on and push the hand–held tester main switch on.  Select the data list mode on the hand–he ...

Rear axle beam assy
Replacement Hint: components:  1. Remove rear wheel  remove the rh and lh rear wheels. 2. Remove rear brake drum sub–assy 3. Separate skid control sensor wire Disconnect the skid control sensor connector.  remove the 2 bolts and separate the wire harness clamp ...

Circuit description
When the idle switch is turned on, a signal is sent to the cruise control ecu assy. The cruise control ecu assy uses this signal to correct the discrepancy between the throttle valve position and the actuator position sensor values to enable accurate cruise control at the set speed. If the idl ...