Toyota Corolla (E120): Drive shaft, propeller shaft, axle

Share this page:

Other materials:

Inspection
1. Fuel injector assy Inspect injector resistance.  Using an ohmmeter,measure the resistance between the terminals. Resistance: 13.4 – 14.2 Ω at 20 c (68 f) Inspect injector inspection Caution: keep injector clear of sparks during the test.  Purch ...

Toyota vehicle intrusion protection system
On–vehicle inspection 1. Outline of toyota vehicle intrusion protection (tvip) system Hint: the theft deterrent system has 2 modes; one is the active mode that is an initially set mode and another is the passive mode that can be switched on/off by the specified method (see step 4). &nb ...

Inspection
1. Spark plug Notice: never use a wire brush for cleaning. Never attempt to adjust the electrode gap on used spark plug. Spark plug should be replaced every 192,000 km (120,000 miles). Clean the spark plugs. Air pressure: below 588 kpa (6.0 Kg/cm2, 85 psi) duration: 20 sec ...