Toyota Corolla (E210): For safe use

Share this page:

Other materials:

Inspection procedure
1 Check side squib(rh) circuit(airbag sensor assy center – front seat airbag assy rh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds. disconnect the connectors between the front seat airbag assy (rh) and the airbag sensor assy center. ...

Dtc check/clear
1. Dtc check (normal mode) Notice: hand–held tester only: when the diagnostic system is switched from the normal mode to the check mode, all the dtcs and freeze frame data recorded in the normal mode will be erased. So before switching modes, always check the dtcs and freeze frame data, and ...

Adjustment
1. Put vehicle these conditions  tire inflation pressure is the specified value .  start the engine. 2. Adjust fog light aim The fog light aim can be adjusting by moving the aiming screw in the vertical direction. Hint: the optical aim moves upward when turning a scr ...