Toyota Corolla (E120): Clutch switch circuit

Share this page:

Other materials:

Inspection procedure
1 Check operation(starter) Check that the starter operates normally and that the engine starts. 2 Input signal check See input signal check on page 05–745.  check the indicator light when shifting into except d position. Ok: the indicator light goes off when shifting ...

Inspection procedure
1 Check source voltage Measure the voltage of the battery. Ok: voltage: 10 – 14 v 2 Check air bag sensor assy center Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors from the airbag sensor assy ...

Roof drip side finish moulding center lh
Replacement Hint: use the same procedures for the rh side and lh side. The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included. 1. Remove roof drip side finish moulding center lh ...