Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Supplemental restraint system / Open in p squib (2nd step) circuit / Circuit description
Toyota Corolla (E120): Circuit description
The p squib (2nd step) circuit consists of the airbag sensor assy center and instrument panel passenger airbag assy.
It causes the srs to deploy when the srs deployment conditions are satisfied.
Dtc b1186/58 is recorded when an open is detected in the p squib circuit.
Wiring diagram
Other materials:
Circuit description
Refer to dtc p0130
Dtc no.
Dtc detecting condition
Trouble area
P0134
After engine is warmed up, heated oxygen sensor (bank 1
sensor 1) output does not indicate rich (greater than 0.45 V)
even once when conditions (a), (b), (c), (d) and (e) continue for
...
Front door belt moulding assy lh
Replacement
Hint:
the installation procedures are the removal procedures in reverse
order.
Use the same procedures for the rh side and lh side.
1. Remove front armrest assy lh
2. Remove power window regulator master switch assy (w/ power window)
3. Remove front armrest base panel up ...
Inspection procedure
1 Inspect fuse(stop)
Turn the ignition switch to off.
remove the stop fuse from the instrument panel j/b.
check continuity of the stop fuse.
Ok: continuity
2 Inspect stop lamp switch assy
Disconnect the stop lamp switch assy connector.
check continuity betw ...