Toyota Corolla (E170): Checking tires

1 New tread
2 Treadwear indicator
3 Worn tread

The location of treadwear indicators is shown by the “TWI” or “Δ” marks, etc.,

The location of treadwear indicators is shown by the “TWI” or “Δ” marks, etc., molded on the sidewall of each tire.

Check spare tire condition and pressure if not rotated.

    Share this page:

    Other materials:

    Inspection procedure


    Hand–held tester: 1 Check operation of stop light Check if the stop lights go on and off normally when the brake pedal is depressed and released. 2 Inspect stop light switch assy Check the resistance between the terminals when the switch is turned on and off. Standard: ...

    For vehicles equipped with catalytic converter
    Caution: if large amount of unburned fuel flows into the converter, it may cause overheating and a fire hazard. To prevent this, observe the following precautions. Use only unleaded gasoline.  avoid prolonged idling. Avoid running the engine at idle speed for more than 20 minutes. ...

    Pre–check
    1. Diagnosis system Release the parking brake lever.  check the warning lights. When the ignition switch is turned on, check that the abs warning light and brake warning light goes on for 3 sec. Hint: when the parking brake is applied or the level of the brake fluid is low, the ...