Toyota Corolla (E140) 2007–2013 Body Repair Manual / Paint coating / Body panel sealing areas
Toyota Corolla (E140): Body panel sealing areas
Be sure to apply body sealer to the body panel joints and door edges (tip of outer panel folded part), etc., To waterproof and rustproof them.
Hint:
- apply degreasing agent to a clean cloth and clean the sealer application areas.
- After removing the applied spot sealer from the sealer application areas using thinner or equivalent, rustproof the areas by applying primer or equivalent. Then apply body sealer.
- If sealer is unnecessarily applied to an area, apply degreasing agent to a clean cloth and clean off the sealer immediately.
|
|
Flat finishing |
|
No flat finishing |
1. Engine compartment
2. Inside
3. Outside
4. Door parts
Other materials:
Hydraulic test
1. Perform hydraulic test
Measure the line pressure.
Notice:
Do the test at normal operation atf temperature 50 to 80 °c (122 to
176 °f).
The line pressure test should always be carried out in pairs. One
technician should observe
the conditions of wheels or wheel stopper outsi ...
Circuit description
The fuel trim is related to the feedback compensation value, not to the basic
injection time. The fuel trim includes
the short–term fuel trim and the long–term fuel trim.
The short–term fuel trim is the short–term fuel compensation used to maintain
the air–fuel ratio at stoichiomet ...
Inspection procedure
1 Inspect terminal voltage(od – body ground)
Disconnect the cruise control ecu connector.
turn the ignition switch to the on position.
measure the voltage between terminal od of cruise control
ecu and body ground.
Standard:
2 Inspect terminal voltage(od1 – bod ...