Toyota Corolla (E120): Wiring diagram
1 Inspect terminal voltage(pi) (a) turn

- Turn the ignition switch to on.
- measure voltage between terminal 5 (pi) of cruise control
ecu assy and body ground, when the cruise control main
switch button is on and off.
Ok:



2 Inspect combination meter assy


3 Check harness and connector(between cruise control ecu assy and combination meter assembly)
- Check for open and short circuit in harness and connector between cruise control ecu assy and combination meter assembly


Check and replace cruise control ecu assy
Other materials:
Inspection procedure
1 Check p squib circuit(airbag sensor assy center – instrument
panel passenger airbag assy)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connector between the airbag sensor
assy center and the instrument panel ...
On–vehicle inspection
1. Horn button assy (vehicles not involved in
collision)
Check the diagnostic system .
visually check the following item with the horn button assy
(with airbag) installed in the vehicle.
Check cuts, minute cracks or marked discoloration on the
horn button assy top surface and in the ...
Deactivating or stopping the alarm
Do one of the following to deactivate or stop the alarm:
● Unlock the doors or open the trunk.
● Vehicles without a smart key system:
Turn the engine switch to the “ACC” or “ON” position, or start the engine. (The
alarm will be deactivated or stopped after a few seconds.)
& ...


