Toyota Corolla (E170): Sound setting

1 Display the “Phone/Message Settings” screen. 2 Select “Sound Settings” on the “Phone/Message Settings” screen.

1 Set the desired ringtone.

2 Adjust the ringtone volume.

3 Adjust the message readout volume.

4 Set the desired incoming SMS/MMS tone.

5 Adjust the incoming SMS/ MMS tone volume.

6 Set the incoming e-mail tone.

7 Adjust the incoming e-mail tone volume.

8 Adjust the default volume of the other party's voice.

■To return to the default volume settings

■To return to the default volume settings

Select “Default”, and then “Yes”.

    Share this page:

    Other materials:

    Problem symptoms table
    Hint: proceed with troubleshooting of each circuit in the table below. Symptom Suspect area When the ignition switch is in the on position, the srs warning light sometimes comes on after approximately 6 seconds.  Srs warning light ci ...

    Inspection
    1. Spark plug Notice: never use a wire brush for cleaning. Never attempt to adjust the electrode gap on used spark plug. Spark plug should be replaced every 192,000 km (120,000 miles). Clean the spark plugs. Air pressure: below 588 kpa (6.0 Kg/cm2, 85 psi) duration: 20 sec ...

    Circuit description
    The p/t squib (lh) circuit consists of the airbag sensor assy center and seat belt pretensioner (lh). It causes the srs to deploy when the srs deployment conditions are satisfied. Dtc b0135/73 is recorded when a short is detected in the p/t squib (lh) circuit. Wiring diagram ...