Toyota Corolla (E120) 2002–2008 Repair Manual / Lighting / Back up lamp assy lh
Toyota Corolla (E120): Back up lamp assy lh
Replacement
1. Remove back up lamp assy lh

- Remove the service hole cover.
- remove the 2 nuts and disconnect the connector.

- Using a mouldingremover, remove the 2 clips and back up light assy lh.
2. Install back up lamp assy lh

- Set the 2 clips on the back up light assy lh as shown in the illustration.
- connect the connector.
- install the back up light lh with 2 nuts.
Other materials:
Overhaul
Hint: component:
1. Discharge refrigerant from refrigeration system
sst 07110–58060 (07117–58080, 07117–58090, 07117–78050, 07117–88060,
07117–88070,
07117–88080)
2. Disconnect cooler refrigerant suction hose no.1
Install sst to piping clamp.
Sst 09870–00015
Hint ...
Oxygen sensor monitor (front and rear o2s system)
Preconditions
The monitor will not run unless:
mil is off
drive pattern
connect the obd ii scan tool to the dlc3 to check monitor status
and preconditions.
Start the engine and allow it to idle for 2 minutes or more.
Drive the vehicle at 25 mph ...
Circuit description
Refer to dtc p0130
Dtc no.
Dtc detection condition
Trouble area
P0133
After engine has been warmed up, if response time that heated
oxygen sensor’s output voltage reaches from rich to lean.
Or from lean to rich, is 0.6 Second or more during idling.
...


