Toyota Corolla (E170): Bluetooth® phone settings

You can adjust the hands-free system to your desired settings.

Share this page:

Other materials:

Pressing power switch does not start system
Wiring diagram Inspection procedure 1 Inspect radio receiver assy(+b, acc, gnd) Check that the continuity between terminals at each condition, as shown in the chart. Standard: Check that the voltage between terminals at each condition, as shown in the chart. Standard: ...

On–vehicle inspection
1. Inspect air–fuel ratio compensation system Hint: you can also check the system by choosing ”data monitor”, then ”o2 sensor output voltage” on the monitor of the hand–held tester. Connect the hand–held tester to the terminal 23 (ox1a) @ 7 (e1) and 21 (ox1b) @ 7 (e1) of ...

Check short circuit
If the wire harness is ground shorted as shown in fig. 5, Locate the section by conducting a resistance check with the body ground in step (b). Check the resistance with the body ground.  Disconnect connectors a and c and measure the resistance between terminals 1 and 2 ...