Toyota Corolla (E120): Theft deterrent & door lock

Share this page:

Other materials:

Replacement
Hint: components: 1. Precaution 2. Disconnect battery negative terminal 3. Remove horn button assy Place the front wheels facing straight ahead.  using a torx socket wrench (t30), loosen the 2 torx screws until the groove along the screw circumference catches on the screw ca ...

Oxygen / af sensor heater monitor
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...

Stabilizer bar rear
Replacement Hint: components: 1. Remove stabilizer bar rear Remove the 2 bolts, nuts and stabilizer bar. 2. Install stabilizer bar rear Install the 2 bolts, nuts and stabilizer bar. Torque: 195 nvm (1,990 Kgf·cm, 144 ft·lbf) Hint: install the stabilizer bar so that the ...