Toyota Corolla (E120): Precaution
1. Notices when checking
- power door lock/unlock function: the wireless remote control function operates only when the following 3 conditions are met.
- No key is inserted into the ignition key cylinder.
- All the doors are closed. However, doors can be unlocked even when any of the doors is opened.
- The power door lock system operates normally.
Hint
:
- the unlock function operates even when a door is open.
- The unlock function operates even when the key is inserted into the ignition key cylinder, however it must be in the off position.
- remote panic function: the wireless remote control function operates only when the following condition is met.
- The ignition switch is off.
Hint
: the key can be inserted, however it must be in the off position.
- the wireless door lock remote control operational area differs depending on the situation.
- The operational area differs depending on the operators and the ways the transmitter is held.
- In certain areas, the remote control function will only operate partially for the operational area will be reduced due to the vehicle body shape and the influence of the surrounding environment.
- Since the transmitter uses faint electric waves, strong electric waves or noise in the frequency used may reduce the operational area or the remote control may not function.
- When the battery weakens, the operational area is reduced or the remote control may not function.
Hint
: if the door control transmitter has been left in a place that is exposed to direct sunlight, such as on the instrument panel, it may cause the battery to weaken or cause other such problems.
Other materials:
Purpose of the readiness tests
The on–board diagnostic (obd ii) system is designed to monitor the
performance of emission–related
components and report any detected abnormalities in the form of diagnostic
trouble codes
(dtcs). Since the various components need to be monitored during different
driving condition ...
Brake fluid
■ Checking fluid level
The brake fluid level should be between the “MAX” and “MIN” lines on the tank.
■ Adding fluid
Make sure to check the fluid type and prepare the necessary item.
1 Slide and lift up the rubber strip to partially remove it as shown.
2 Disconnect the ...
On–vehicle inspection
1. Inspect pressure switch no.1.
Magnetic clutch control:
inspect pressure switch operation.
Set on the manifold gauge set.
Connect the positive (+) lead from the ohmmeter to
terminal 4 and the negative (–) lead to terminal 1.
Check continuity between termin ...


