Toyota Tacoma manuals

Toyota Corolla Repair Manual: Short in d squib circuit (to ground)

Toyota Corolla Repair Manual / Diagnostics / Supplemental restraint system / Short in d squib circuit (to ground)

Dtc b0102/11 short in d squib circuit (to ground)

Inspection procedure
1 Check d squib circuit(airbag sensor assy center horn button assy) Disconnect the negative () terminal cable from the battery, and wait at least for 90 seconds.  disconnect the c ...

Circuit description
The d squib circuit consists of the airbag sensor assy center, spiral cable subassy and horn button assy. It causes the srs to deploy when the srs deployment conditions are satisfied. Dtc b01 ...

Other materials:

Rear seats
► Type A 1 Up Pull the head restraints up. 2 Down Push the head restraint down while pressing the lock release button. ► Type B 1 Up Pull the head restraints up. 2 Down Push the head restraint down while pressing the lock release button. ■Removing the head restraints ...

Inspection procedure
1 Inspect dlc3 terminal voltage(ts terminal) Turn the ignition switch to on. measure voltage between terminals ts and cg of dlc3. Ok: voltage: 10 14 v 2 Check harness and connector(dlc3 body ground) Check for open and short circuit in harness and connector between ter ...

Circuit description
If the engine coolant temperature (ect) does not reach 75c (167f) despite sufficient warm up time has elapsed. Dtc no Dtc detection condition Trouble area P0128 Condition (a), (b) and (c):  cold start  after engine is warmed up   ...

2011-2019 Copyright www.tcorolla.net