Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Supplemental restraint system / Short in d squib circuit (to ground) / Circuit description
Toyota Corolla (E120): Circuit description
The d squib circuit consists of the airbag sensor assy center, spiral cable sub–assy and horn button assy.
It causes the srs to deploy when the srs deployment conditions are satisfied.
Dtc b0102/11 is recorded when a ground short is detected in the d squib circuit.

Wiring diagram
Other materials:
On–vehicle inspection
1. Check battery electrolyte level
Check the electrolyte quantity of each cell (maintenance–free battery).
If under the lower level, replace the battery (or add distilled
water if possible) and check the charging
system.
check the electrolyte quantity of each cell ...
Pre–check
1. Diagnosis system
Release the parking brake lever.
check the warning lights.
When the ignition switch is turned on, check that the abs
warning light and brake warning light goes on for 3 sec.
Hint:
when the parking brake is applied or the level of the brake
fluid is low, the ...
Circuit description
In the diagram below, when the engine is cranked, current flows from terminal
st2 of the ignition switch to
the starter relay coil and also current flows to terminal sta of the ecm (sta
signal).
When the sta signal and ne signal are input to the ecm, tr is turned on, current
flows to the c ...


