Toyota Corolla Repair Manual: Shift solenoid ”b” performance (shift solenoid valve s2)
Dtc p0756 shift solenoid ”b” performance (shift solenoid valve s2)
Inspection procedure
1 Inspect shift solenoid valve(s1)
Remove the shift solenoid valve s1.
measure the resistance according to the value(s) in the
table below.
Standard:
Connect the positive (+) batt ...
System description
The ecm uses signals from the vehicle speed sensor and crankshaft position
sensor to detect the actual
gear position (1st, 2nd, 3rd or o/d gear).
Then the ecm compares the actual gear with the s ...
Other materials:
Inspection procedure
1 Check d squib circuit(airbag sensor assy center – horn button
assy)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connectors between the horn button assy
and the airbag sensor assy center.
for the black co ...
Lower ball joint assy front lh
Replacement
Hint: components:
1. Inspect lower ball joint assy front lh
Jack up front side of the vehicle.
check the rattle of the lower ball joint assy front lh.
2. Remove front wheel
3. Remove front axle hub lh nut
sst 09930–00010
4. Disconnect speed sensor front lh (w/ ab ...
Shifting the shift lever to R
Shift the shift lever to R while lifting up the ring section.
■Maximum allowable speeds
Observe the following maximum allowable speeds in each gear when maximum acceleration
is necessary.
mph (km/h)
NOTICE
■To prevent damage to the transmission
●Do not lift up the ring ...