Toyota Corolla (E120): Oil pump assy

Share this page:

Other materials:

Oxygen sensor monitor (front and rear o2s system)
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...

Correct use of the seat belts
Extend the shoulder belt so that it comes fully over the shoulder, but does not come into contact with the neck or slide off the shoulder. Position the lap belt as low as possible over the hips. Adjust the position of the seatback. Sit up straight and well back in the seat. Do not twist ...

Inspection procedure
1 Inspect terminal voltage(od – body ground) Disconnect the cruise control ecu connector.  turn the ignition switch to the on position.  measure the voltage between terminal od of cruise control ecu and body ground. Standard: 2 Inspect terminal voltage(od1 – bod ...