Toyota Corolla (E120): Evaporative emission control system leak detected

Inspection procedure

Circuit description

Other materials:

Disposal
1. Dispose shock absorber assy rear lh Fully extend the shock absorber rod.  using a drill, make a hole in the cylinder as shown in the illustration to discharge the gas inside. Caution: when drilling, chips may fly out, work carefully. The gas is colorless, odorless and no ...

Fail–safe chart
If any of the following codes is recorded, the ecm enters the fail–safe mode. Check for intermittent problems Hand–held tester only: by putting the vehicle’s ecm in the check mode, the 1 trip detection logic is possible instead of the 2 trip detection logic, and the sensitivity to de ...

Out side moulding
Replacement Hint: use the same procedures for the rh side and lh side. 1. Remove outside moulding Put protective tape around the moulding.  insert a piano wire between the vehicle body and moulding.  tie objects that can serve as handles (for example, wooden blocks) to all ...