Toyota Corolla Repair Manual: Engine coolant temp. Circuit range/performance problem

Inspection procedure

Hint: if different dtcs related to different systems that have terminal e2 as the ground terminal are output simultaneously, terminal e2 may be open. Read freeze frame data using the hand-h ...

Circuit description

Refer to dtc p0115 Dtc no. Dtc detection condition Trouble area P0116 If engine coolant temperature (ect) was between 35 c (95 °F) and 60 c (140 °F) when starting the ...

Other materials:

Fail–safe chart
If any of the following codes is recorded, the ecm enters the fail–safe mode. Check for intermittent problems Hand–held tester only: by putting the vehicle’s ecm in the check mode, the 1 trip detection logic is possible instead of the 2 trip detection logic, and the sensitivity to detect f ...

Malfunction in fuel receiver gauge
Wiring diagram Inspection procedere 1 Inspect fuel sender gage assy Disconnect the connector fuel sender gauge. check the float position between e and f and measure the resistance between terminals 2 and 3 of the connector. Check that the resistance value changes continuously. S ...

Indicators
The indicators inform the driver of the operating state of the vehicle’s various systems. *1: Vehicles without a smart key system: These lights turn on when the engine switch is turned to the “ON” position to indicate that a system check is being performed. They will turn off after the engin ...