Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Sfi system / Engine coolant temp. Circuit
range/performance problem / Inspection procedure
Toyota Corolla (E120): Inspection procedure
Hint
:
- if dtcs p0115, p0116, p0117, p0118 and p0125 are output simultaneously, the engine coolant temperature sensor circuit may be open or short. Perform the troubleshooting of dtc p0115, p0117 or p0118 first.
- Read freeze frame data using the hand-held tester or the obd ii scan tool. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, it is useful for determining whether the vehicle was running or stopped, the engine was warmed up or not, the air–fuel ratio was lean or rich, etc. At the time of the malfunction.
Replace engine coolant temperature sensor
Other materials:
Lower ball joint assy front lh
Replacement
Hint: components:
1. Inspect lower ball joint assy front lh
Jack up front side of the vehicle.
check the rattle of the lower ball joint assy front lh.
2. Remove front wheel
3. Remove front axle hub lh nut
sst 09930–00010
4. Disconnect speed sensor front lh (w/ ...
Safety information for
Safety Connect
Important! Read this information
before using Safety Connect.
■ Exposure to radio frequency
signals
The Safety Connect system
installed in your vehicle is a
low-power radio transmitter and
receiver. It receives and also
sends out radio frequency (RF)
signals.
In August 1996, the Federal
Communica ...
Rear wheel alignment
Inspection
1. Inspect tire
2. Measure vehicle height
Notice:
before inspecting the wheel alignment, adjust the vehicle height to the
specified value.
3. Inspect toe–in
Toe–in:
usa, canada:
Mexico:
If the toe–in is not within the specified value, inspect and replace
the susp ...


