Toyota Corolla (E120): Disposal

1. Dispose shock absorber assy front lh

  1.  fully extend the shock absorber piston rod.
  2.  using a drill, make a hole in the cylinder as shown in the illustration to discharge the gas inside.

Caution

:

  • when drilling, chips may fly out, work carefully.
  • The gas is colorless, odorless and non–poisonous.
    Share this page:

    Other materials:

    Circuit description
    The ignition switch provides circuit power and the ecm provides the circuit ground that illuminates the mil. Mil operation is checked visually: it should be illuminated when the ignition is first turned on. If the mil is off all of the time or on all of the time, use the procedure below to ...

    Oxygen / af sensor heater monitor
    Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...

    Using the radio
    Radio operation Select “AM” or “FM” to begin listening to the radio. 1 Power 2 Volume 3 Station selectors 4 Adjust frequency or select an item 5 AM/FM mode button 6 Scan for receivable stations 7 Seek a frequency Setting station presets 1Search for a desired station by turning ...