Toyota Corolla (E120): Front shock absorber with coil spring

Front wheel alignment

Overhaul

Other materials:

Oxygen / af sensor heater monitor
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...

Checking and replacing fuses
If any of the electrical components do not operate, a fuse may have blown. If this happens, check and replace the fuses as necessary. 1 Turn the engine switch off. 2 Open the fuse box cover. ► Engine compartment Push the tab in and lift the lid off. ► Under the driver’s side i ...

How to proceed with troubleshooting
Hint: carry out troubleshooting in accordance with the procedures on the following page. Here, only the basic procedures are shown. Details are provided in the diagnostics section, showing the most effective methods for each circuit. Confirm the troubleshooting procedures first for the releva ...