If a dtc is displayed during the dtc check, check the circuit listed in the table below and proceed to the page given.
* :● ... Mil light up
Inspection procedure
1 Check connector
Disconnect the negative (–) terminal cable from the battery, and wait at
least for 90 seconds.
check the connection of the combination meter connector and the
airbag sensor assy center connectors.
Ok:
the connectors are connected.
2 Check combination me ...
Engine oil
With the engine at operating temperature and turned off, check the oil level
on the dipstick.
■ Checking the engine oil
1 Park the vehicle on level ground. After warming up the engine and turning it
off, wait more than 5 minutes for the oil to drain back into the bottom of the engine.
2 ...
Manual shifting test
1. Perform manual shifting test
Hint:
by this test, it can be determined whether the trouble is within
the electrical circuit or is a mechanical problem in the transaxle.
Disconnect the transmission wire connector.
inspect the manual driving operation.
Check that the shift and g ...