Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Supplemental restraint system / Open in p/t (rh) circuit / Circuit description
Toyota Corolla (E120): Circuit description
The p/t squib circuit (rh) consists of the airbag sensor assy center and seat belt pretensioner (rh).
It causes the srs to deploy when the srs deployment conditions are satisfied.
Dtc b0131/64 is recorded when an open is detected in the p/t squib (rh) circuit.

Wiring diagram
Other materials:
Replacement
1. Drain brake fluid
Notice:
wash the brake fluid off immediately if it comes into contact with any painted
surface.
2. Remove front wheel rh
3. Remove front fender liner rh
4. Remove brake actuator with bracket
turn the latch of the actuator connector to disconnect the
connector. ...
Shifting the shift lever
Vehicles without a smart key system:
While the engine switch is in the “ON” position, depress the brake pedal and
move the shift lever.
Vehicles with a smart key system: While the engine switch is in IGNITION ON mode,
depress the brake pedal and move the shift lever.
When shifting the ...
Replacement
Hint:
installation is in the reverse order of the removal. But the installation is
indicated only when it has a point.
1. Remove spare wheel cover assy
2. Remove rear floor finish plate
Remove the 3 clips.
using a moulding remover, remove the rear floor finish
plate.
3. Rem ...


