Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Supplemental restraint system / Front airbag sensor (rh)
malfunction / Circuit description
Toyota Corolla (E120): Circuit description
The airbag front rh sensor circuit consists of the airbag sensor assy center and airbag front rh sensor.
Dtc b1156/b1157/15 is recorded when a malfunction is detected in the airbag front rh sensor circuit.
Wiring diagram
Other materials:
Inspection procedure
1 Check hazard warning signal switch assy
Check the hazard warning switch continuity, as shown in
the illustration and table.
Standard:
2 Check turn signal flasher assy
3 Check wire harness (tvip ecu turn signal flasher)
Disconnect the tvip ecu and turn signal flashe ...
Inspection procedure
1 Check harness and connector(transmission control switch –
body ground)
Disconnect the transmission control switch connector of
shift lever assy.
measure the resistance according to the value(s) in the
table below.
Standard:
2 Inspect transmission control switch
M ...
Fail–safe chart
If any of the following codes is recorded, the ecm enters the fail–safe mode.
Check for intermittent problems
Hand–held tester only:
by putting the vehicle’s ecm in the check mode, the 1 trip detection logic is
possible instead of the
2 trip detection logic, and the sensitivity to de ...