Toyota Corolla (E120): Circuit description

The p squib circuit consists of the airbag sensor assy center and instrument panel passenger airbag assy.

It causes the srs to deploy when the srs deployment conditions are satisfied.

Dtc b0106/54 is recorded when an open is detected in the p squib circuit.

Wiring diagram

Wiring diagram

    Share this page:

    Other materials:

    Dtc check/clear
    Notice: if there is no dtc in the normal mode, check the pending fault code using the continuous test results function (mode 7 for sae j1979) on the obd ii scan tool or the hand–held tester. Hand–held tester only: when the diagnosis system is switched from the normal mode to the ...

    Transmission valve body assy (atm)
    Replacement 1. Remove engine under cover lh 2. Drain automatic transaxle fluid  remove the drain plug, gasket and drain atf.  install a new gasket and drain plug. Torque: 17.5 Nvm (178 Kgf·cm, 13 ft·lbf) 3. Remove automatic transaxle oil pan sub–assy Remove the 18 ...

    On–vehicle inspection
    1. Check fuel pump operation Connect the hand–held tester to the dlc3.  turn the ignition switch on and hand–held tester main switch on. Notice: do not start the engine.  select the active test mode on the hand–held tester.  please refer to the hand–held te ...