Toyota Tacoma manuals

Toyota Corolla Repair Manual: Camshaft position sensor a circuit

Toyota Corolla Repair Manual / Diagnostics / Sfi system / Camshaft position sensor a circuit

Dtc p0340 camshaft position sensor a circuit (bank 1 or single sensor)

Dtc p0341 camshaft position sensor a circuit range/performance (bank 1 or single sensor)

Inspection procedure
Hint: perform the troubleshooting of dtc p0335 first. If no trouble is found, troubleshoot the engine mechanical systems. Read freeze frame data using the hand-held tester or the obd ii sca ...

Circuit description
The camshaft position sensor (g22+ signal) consists of a magnet, iron core and pickup coil. The g22+ signal plate has 3 teeth on its outer circumference and is installed on the camshaft timing ...

Other materials:

Inspection procedure
1 Inspect park/neutral position switch assy Disconnect the park/neutral position switch connector.  measure resistance according to the value(s) in the table below when the shift lever is moved to each position. Standard: 2 Check harness and connector(park/neutral position ...

Circuit description
Refer to dtc p0130 Dtc no Dtc detection condition Trouble area P0136 The following condition (a) or (b) continues for 300 seconds or more: During driving with the engine warmed up, heated oxygen sensor o tp t does not change output change. he ...

Overhaul
1. Remove roof headlining assy 2. Remove sliding roof glass subassy  using a torx wrench (t25), remove the 4 screws the sliding roof glass.  pull the glass upward to remove it. 3. Remove sliding roof weatherstrip 4. Remove sliding roof drive gear subassy Notice: remo ...

2011-2019 Copyright www.tcorolla.net