Toyota Corolla (E170): Sun visors

1 To set the visor in the forward position, flip it down.

2 To set the visor in the side position, flip down, unhook, and swing it to the side.

Vanity mirrors

    Share this page:

    Other materials:

    Replacement
    Hint: installation is in the reverse order of the removal. But the installation is indicated only when it has a point. 1. Remove spare wheel cover assy 2. Remove rear floor finish plate Remove the 3 clips.  using a moulding remover, remove the rear floor finish plate. 3. Rem ...

    Inspection procedure
    1 Inspect dlc3 terminal voltage(ts terminal) Turn the ignition switch to on. measure voltage between terminals ts and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector between ...

    Inspection procedure
    1 Check low pitched horn assy Connect the positive (+) lead from the battery to the terminal and negative (–) lead to the horn body, and check that the horn blows. 2 Check relay (marking: horn) Remove the relay from the engine room j/b.  check the horn relay conti ...