Toyota Corolla (E170): Registering a Bluetooth® phone for the first time

To use the hands-free system, it is necessary to register a Bluetooth® phone with the system.

Once the phone has been registered, it is possible to use the hands-free system.

For details about registering a Bluetooth® device

1 Turn the Bluetooth® connection setting of your cellular phone on.

2 Press the “3 Select “OK” to register a phone. ” button.

3 Select “OK” to register a phone.

4 Follow the steps in “How to registering a Bluetooth® device” from “STEP 2”.

    Share this page:

    Other materials:

    Diagnostic trouble code chart
    The inspection procedures are shown in the table below. This table allows efficient and accurate troubleshooting using the diagnostic trouble codes displayed in the diagnostic trouble code chart. Proceed with troubleshooting in accordance with the inspection procedures listed in the diagnost ...

    Replacement
    Hint: for parking brake cable assy no.2, Perform the same procedure to the parking brake cable assy no.3. 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Remove rear brake automatic adjust lever lh 4. Remove front brake shoe  sst 09718–00010 5. Remove parking brake sho ...

    Oxygen sensor monitor (front and rear o2s system)
    Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...