Toyota Corolla (E120) 2002–2008 Repair Manual / Automatic transmission / trans / Floor shift cable transmission control shift
Toyota Corolla (E120): Floor shift cable transmission control shift
Replacement
Hint
: components:
1. Remove air conditioner unit assy
Hint
: refer to the instructions for removal of the air conditioner unit assy.
2. Separate air bag sensor assy center
- remove the 3 bolts, separate the airbag sensor assy center.
3. Remove exhaust pipe assy
4. Remove front floor heat insulator no.1
- remove the 3 nuts and heat insulator no.1.
5. Remove floor shift cable transmission control shift
- Remove the clip and washer, separate the top of the shift cable from the transaxle.
- remove the clip, separate the shift cable from the control cable bracket.
- Remove the 2 nuts and clamp.
- Using a screwdriver, release the cable outer spring.
- turn the lock, separate the shift cable from the shift lever retainer.
- Separate the end of the shift cable from the shift lever assy.
- Remove the 2 bolts and retainer from the floor.
- pull out the control cable assy from the floor.
- Remove the retainer from the grommet.
6. Install floor shift cable transmission control shift
- Put the control cable assy through the floor hole and retainer.
- install the retainer to the grommet.
Notice
: fit 4 projections of the grommet into 4 holes of the retainer.
- Install the control cable assy with the 2 bolts.
Torque: 5.0 Nvm (51 Kgf·cm, 44 in.Vlbf)
- Connect the end of the shift cable to the shift lever assy.
- Connect the shift cable to the retainer of shift lever assy,
turn the lock.
Notice
: the projecting part of the lock should face upward when the shift cable is installed.
- install the cable outer spring to the lock.
Notice
: make sure that after installation the cable outer spring is moved to the place shown in the illustration.
- Install the clamp with the 2 nuts.
Torque: 5.0 Nvm (51 Kgf·cm, 44 in.Vlbf)
- Connect the shift cable to the control cable bracket, install a new clip.
- connect the shift cable to the transaxle, install the washer and clip.
7. Install front floor heat insulator no.1
- install the heat insulator no.1 With the 3 nuts.
Torque: 5.5 Nvm (56 Kgf·cm, 49 in.Vlbf)
8. Install exhaust pipe assy
9. Connect air bag sensor assy center
- install the airbag sensor assy center with the 3 bolts.
Torque: 17.5 Nvm (178 Kgf·cm, 13 ft·lbf)
10. Inspect srs warning light
Other materials:
Circuit description
The airbag sensor front lh circuit consists of the airbag sensor assy center
and airbag sensor front lh.
Dtc b1158/b1159/16 is recorded when malfunction is detected in the airbag sensor
front lh circuit.
Wiring diagram
...
Replacement
1. Remove console box sub–assy rear
2. Remove parking brake lever sub–assy
3. Remove exhaust pipe assy front
4. Remove front floor heat insulator no.1
Remove the 3 nuts and front floor insulator no.1.
5. Remove front floor heat insulator no.2
Remove the 2 nuts and front ...
Child restraint systems
Before installing a child
restraint system in the vehicle,
there are precautions
that need to be observed,
different types of child
restraint systems, as well as
installation methods, etc.,
written in this manual.
Use a child restraint system
when riding with a small child
that cannot properly use a ...