Toyota Corolla (E120): Replacement

Hint

: components:

1. Remove floor shift shift lever knob sub–assy

2. Remove console panel upper

3. Remove parking brake hole cover sub–assy

4. Remove console box sub–assy rear

5. Separate floor shift cable transmission control shift

  1. Separate the end of the shift cable from the shift lever assy.

  1. Using a screwdriver, release the cable outer spring.
  2.  turn the lock, separate the shift cable from the shift lever retainer.

6. Separate floor shift cable transmission control select

  1. Separate the end of the select cable from the shift lever assy.

  1. Using a screwdriver, release the cable outer spring.
  2.  turn the lock, separate the select cable from the shift lever retainer.

7. Remove floor shift shift lever assy

  1. Remove the 4 bolts and shift lever assy.

8. Install floor shift shift lever assy

  1. Install the shift lever assy with the 4 bolts.

    Torque: 12 nvm (120 Kgf·cm, 9 ft·lbf)

9. Connect floor shift cable transmission control shift

  1. Connect the shift cable to the retainer of shift lever assy, turn the lock.

    Notice

    : the projecting part of the lock should face upward when the shift cable is installed.

  2.  install the cable outer spring to the lock.

    Notice

    : make sure that after installation the cable outer spring is moved to the place shown in the illustration.

  1. Connect the end of the shift cable to the shift lever assy.

10. Connect floor shift cable transmission control select

  1.  connect the select cable to the retainer of shift lever assy, turn the lock.

    Notice

    : the projecting part of the lock should face upward when the select cable is installed.

  2.  install the cable outer spring to the lock.

    Notice

    : make sure that after installation the cable outer spring is moved to the place shown in the illustration.

  1. Connect the end of the select cable to the shift lever assy.
    Share this page:

    Other materials:

    Inspection procedure
    1 Inspect shift solenoid valve(s2) Remove the shift solenoid valve s2.  measure the resistance according to the value(s) in the table below. Standard: Connect the positive (+) battery lead to the solenoid connector terminal, and the negative (–) battery lead to the so ...

    Body
    On–vehicle inspection 1. Canada: tighten bolts and nuts on chassis and body  tighten the bolts and nuts on the chassis parts listed below, if necessary Front axle and suspension drive train rear axle and suspension brake system engine mounting other chassis parts ...

    Replacement
    Hint: components: 1. Table of bolt, screw and nut Notice: be sure to tape the tip of the screwdriver when using it to disengage the meshing of the clips and claws. Hint: indicate the bolts, screws and nuts, which are necessary for installation and removal of the instrument panel, in th ...