Toyota Corolla Repair Manual: Torque converter clutch solenoid performance (shift solenoid valve sl)

Inspection procedure

1 Inspect stop lamp switch assy 2 Check harness and connector(stop lamp switch assy – ecm)   Install the stop lamp switch assy.  disconnect the ecm connector.  measure the ...

System description

The ecm uses the signals from the throttle position sensor, air–flow meter and crankshaft position sensor to monitor the engagement condition of the lock–up clutch. Then the ecm compares the eng ...

Other materials:

Luggage compartment door
Adjustment 1. Inspect luggage compartment door panel sub–assy  check that the clearance is within the standard value. 2. Adjust luggage compartment door panel sub–assy For forward/rearward and right/left adjustments, loosen the bolts. Torque: 7.0 N·m (71 kgf·cm, 62 in.·Lbf ...

Pressing power switch does not start system
Wiring diagram Inspection procedure 1 Inspect radio receiver assy(+b, acc, gnd) Check that the continuity between terminals at each condition, as shown in the chart. Standard: Check that the voltage between terminals at each condition, as shown in the chart. Standard: ...

Diagnostic trouble code chart
The inspection procedures are shown in the table below. This table allows efficient and accurate troubleshooting using the diagnostic trouble codes displayed in the diagnostic trouble code chart. Proceed with troubleshooting in accordance with the inspection procedures listed in the diagnost ...