Toyota Corolla (E120): Short in p/t squib (rh) circuit

Dtc b0130/63 short in p/t squib (rh) circuit

Share this page:

Other materials:

Correct use of the seat belts
Extend the shoulder belt so that it comes fully over the shoulder, but does not come into contact with the neck or slide off the shoulder. Position the lap belt as low as possible over the hips. Adjust the position of the seatback. Sit up straight and well back in the seat. Do not twist ...

Speed sensor front lh
Replacement Hint: replace the rh side by the same procedure as the lh side. 1. Remove front wheel 2. Remove front fender liner lh 3. Remove speed sensor front lh Disconnect the speed sensor wire harness clamp from the body.  disconnect the speed sensor connector. Remo ...

Roof drip side finish moulding center lh
Replacement Hint: use the same procedures for the rh side and lh side. The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included. 1. Remove roof drip side finish moulding center lh ...