Toyota Tacoma manuals

Toyota Corolla Repair Manual: Short in p/t squib (lh) circuit (to b+)

Toyota Corolla Repair Manual / Diagnostics / Supplemental restraint system / Short in p/t squib (lh) circuit (to b+)

Dtc b0138/72 short in p/t squib (lh) circuit (to b+)

Inspection procedure
1 Check p/t squib(lh) circuit(airbag sensor assy center front seat outer belt assy lh) Disconnect the negative () terminal cable from the battery, and wait at least for 90 seconds. &nb ...

Circuit descriptionCircuit description
The p/t squib (lh) circuit consists of the airbag sensor assy center and seat belt pretensioner (lh). It causes the srs to deploy when the srs deployment conditions are satisfied. Dtc b0138/72 ...

Other materials:

Overhaul
1. Inspect 4th gear thrust clearance Using a feeler gauge, measure the 4th gear thrust clearance. 4Th gear thrust clearance: 2. Inspect 3rd gear thrust clearance Using a dial indicator, measure the 3rd gear thrust clearance. 3Rd gear thrust clearance: 3. Inspect 4th gear ...

Monitor description
While the engine is being cranked, the battery positive voltage is applied to terminal sta of the ecm. If the ecm detects the starter control signal (sta) while the vehicle is driving, it will conclude that there is a fault in the starter control circuit. The ecm will turn on the mil and a d ...

Onvehicle inspection
1. Inspect refrigerant pressure with manifold gauge set  this is a method in witch the trouble is located by using a manifold gauge set. Read the manifold gauge pressure when the these conditions are established. Test conditions: temperature at the air inlet with the switch set ...

2011-2021 Copyright www.tcorolla.net