Toyota Corolla (E120): Short in d squib circuit

Dtc b0100/13 short in d squib circuit

Share this page:

Other materials:

Check and replace ecu
Notice: start an inspection of the connector from the backside of the connector on the wire harness side with the connector connected to the ecu. When no measurement condition is specified, perform the inspection with the engine stopped and also the ignition switch on. First check the ec ...

Replacement
Hint: installation is in the reverse order of the removal. But the installation is indicated only when it has a point. 1. Remove rear door opening trim rh 2. Remove rear door opening trim lh 3. Remove rear seat cushion assembly ( or 72–8) 4. Remove rear seat back assy (fixed type rear seat) ...

Inspection procedure
1 Input signal check See the input signal check on page 05–745.  check the indicator light when the clutch pedal is depressed. Ok: the indicator light goes off when the clutch pedal is depressed. 2 Inspect terminal voltage(d) Turn the ignition switch to on. &n ...