Toyota Corolla (E140): Paint coating

Share this page:

Other materials:

Shifting the shift lever to R
Shift the shift lever to R while lifting up the ring section. ■Maximum allowable speeds Observe the following maximum allowable speeds in each gear when maximum acceleration is necessary. mph (km/h) NOTICE ■To prevent damage to the transmission ●Do not lift up the ring ...

Oxygen sensor monitor (front and rear o2s system)
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...

Inspection procedure
1 Check relay (marking: starter cut) Inspect the relay continuity, as shown in the illustration and table. Standard: 2 Check tvip ecu Disconnect the tvip ecu connector.  turn the ignition switch position to the start.  measure the voltage between the termina ...