Toyota Corolla (E140): Silencer sheet installation areas

Substitute silencer sheets for the laminate coat application areas.

    Share this page:

    Other materials:

    Skid control sensor
    Replacement Hint: replace the rh side by the same procedure as the lh side. 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Disconnect skid control sensor wire Disconnect the skid control sensor wire connector from the skid control sensor. 4. Remove rear axle hub & ...

    Circuit description
    The d squib circuit consists of the airbag sensor assy center, spiral cable sub–assy and horn button assy. It causes the srs to deploy when the srs deployment conditions are satisfied. Dtc b0100/13 is recorded when a short is detected in the d squib circuit. Wiring diagram ...

    Circuit description
    When driving uphill under cruise control, in order to reduce the number of shifting due to on–off overdrive operation and to provide smooth driving, when down shifting in the electronically controlled transmission occurs, a signal to prevent upshift until the end of the uphill slope is sent ...