Toyota Corolla (E170): Operation

To turn the compass on or off, press and hold “AUTO” for 3 seconds.

Displays and directions

    Share this page:

    Other materials:

    Dtc check/clear
    1. Dtc check (normal mode) Notice: hand–held tester only: when the diagnostic system is switched from the normal mode to the check mode, all the dtcs and freeze frame data recorded in the normal mode will be erased. So before switching modes, always check the dtcs and freeze frame data, and ...

    On–vehicle inspection
    1. Washer motor Operation check pour the water into the washer jar with the washer motor and the pump installed to the washer jar assy.  Connect the battery (+) to terminal 2 of the washer motor and the pump, the battery (–) to terminal 1 of the washer motor and the pump ...

    Inspection procedure
    1 Inspect transmission wire(s1) Disconnect the transmission wire connector from the transaxle.  measure the resistance according to the value(s) in the table below. Standard: 2 Check harness and connector(transmission wire – ecm) Connect the transmission connec ...