Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Electronic controlled automatic transaxle / Manual shifting test
Toyota Corolla (E120): Manual shifting test
1. Perform manual shifting test
Hint
: by this test, it can be determined whether the trouble is within the electrical circuit or is a mechanical problem in the transaxle.

- Disconnect the transmission wire connector.
- inspect the manual driving operation.
Check that the shift and gear positions correspond to the table below.
While driving, shift through the l, 2 and d positions.
Check that the gear change corresponds to the shift position.

Hint
: if the gear positions of the l, 2 and d are difficult to distinguish, do the following road test.
If any abnormality is found in the above test, the problem is in the transaxle itself.
- Connect the transmission wire connector.
- clear the dtc
Other materials:
Disabling the TRAC system
If the vehicle gets stuck in mud, dirt or snow, the TRAC system may reduce power
from the engine to the wheels. Pressing
to turn the system off may make it
easier for you to rock the vehicle in order to free it.
To turn the TRAC system off, quickly press and release
.
The “TRAC OFF” ind ...
Inspection
1. Intake air flow meter sub–assy
Inspect the intake air flow meter resistance.
Using an ohmmeter, measure the resistance between
terminals tha and e2.
Resistance:
at –20 c (–4 f) 13.6 To 18.4 KΩ
at 20 c (68 f) 2.21 To 2.69 KΩ
at 60 c (140 f) 0.49 To 0.67 ...
Problem symptoms table
Hint:
proceed with troubleshooting of each circuit in the table below.
Symptom
Suspect area
When the ignition switch is in the on position, the srs warning
light sometimes comes on after approximately 6 seconds.
Srs warning light ci ...


