Toyota Tacoma manuals

Toyota Corolla Owners Manual: Installing the spare tire

1 Remove any dirt or foreign matter from the wheel contact surface.

If foreign matter is on the wheel contact surface, the wheel nuts may loosen while the vehicle is in motion, causing the tire to come off.

2 Install the tire and loosely tighten each wheel nut by hand by approximately

2 Install the tire and loosely tighten each wheel nut by hand by approximately the same amount.

When replacing a steel wheel with a compact spare tire, tighten the wheel nuts until the tapered portion comes into loose contact with the disc wheel seat.

When replacing an aluminum wheel with a compact spare tire, tighten the wheel

When replacing an aluminum wheel with a compact spare tire, tighten the wheel nuts until the tapered portion comes into loose contact with the disc wheel seat.

3 Lower the vehicle.

3 Lower the vehicle.

4 Firmly tighten each wheel nut two or three times in the order shown in the

4 Firmly tighten each wheel nut two or three times in the order shown in the illustration.

Tightening torque:
76 ftlbf (103 Nm, 10.5 kgfm)

5 Stow the flat tire, tire jack and all tools.

5 Stow the flat tire, tire jack and all tools.

■The compact spare tire

●The compact spare tire is identified by the label TEMPORARY USE ONLY on the tire sidewall.

Use the compact spare tire temporarily, and only in an emergency.

●Make sure to check the tire inflation pressure of the compact spare tire.

 

■When the compact spare tire is equipped

The vehicle becomes lower when driving with the compact spare tire compared to when driving with standard tires.

■After completing the tire change (vehicles with a tire pressure warning system)

The tire pressure warning system must be reset. ■When using the compact spare tire (vehicles with a tire pressure warning system)

As the compact spare tire is not equipped with a tire pressure warning valve and transmitter, low inflation pressure of the spare tire will not be indicated by the tire pressure warning system. Also, if you replace the compact spare tire after the tire pressure warning light comes on, the light remains on.

■If you have a flat front tire on a road covered with snow or ice

Install the compact spare tire on one of the rear wheels of the vehicle.

Perform the following steps and fit tire chains to the front tires: 1 Replace a rear tire with the compact spare tire.

2 Replace the flat front tire with the tire removed from the rear of the vehicle.

3 Fit tire chains to the front tires.

■When reinstalling the wheel ornament (vehicles with steel wheels)

Align the cutout of the wheel ornament with the valve stem as shown the illustration.

CAUTION

CAUTION

■When using the compact spare tire

●Remember that the compact spare tire provided is specifically designed for use with your vehicle. Do not use your compact spare tire on another vehicle.

●Do not use more than one compact spare tires simultaneously.

●Replace the compact spare tire with a standard tire as soon as possible.

●Avoid sudden acceleration, abrupt steering, sudden braking and shifting operations that cause sudden engine braking.

■When the compact spare tire is attached

The vehicle speed may not be correctly detected, and the following systems may not operate correctly:

ABS & Brake assist VSC
TRAC
Cruise control (if equipped) EPS
Rear view monitor system (if equipped) Navigation system (if equipped)

■Speed limit when using the compact spare tire

Do not drive at speeds in excess of 50 mph (80 km/h) when a compact spare tire is installed on the vehicle.

The compact spare tire is not designed for driving at high speeds. Failure to observe this precaution may lead to an accident causing death or serious injury.

■After using the tools and jack

Before driving, make sure all the tools and jack are securely in place in their storage location to reduce the possibility of personal injury during a collision or sudden braking.

NOTICE

■Be careful when driving over bumps with the compact spare tire installed on the vehicle

.

The vehicle becomes lower when driving with the compact spare tire compared to when driving with standard tires. Be careful when driving over uneven road surfaces.

■Driving with tire chains and the compact spare tire

Do not fit tire chains to the compact spare tire.

Tire chains may damage the vehicle body and adversely affect driving performance.

■When replacing the tires (vehicles with a tire pressure warning system)

When removing or fitting the wheels, tires or the tire pressure warning valve and transmitter, contact your Toyota dealer as the tire pressure warning valve and transmitter may be damaged if not handled correctly.

■To avoid damage to the tire pressure warning valves and transmitters (vehicles with a tire pressure warning system)

When a tire is repaired with liquid sealants, the tire pressure warning valve and transmitter may not operate properly. If a liquid sealant is used, contact your Toyota dealer or other qualified service shop as soon as possible. Make sure to replace the tire pressure warning valve and transmitter when replacing the tire.

Replacing a flat tire
1 Chock the tires. 2 For vehicles with steel wheels, remove the wheel ornament using the wrench. To protect the wheel ornament, place a rag between the wrench and the wheel ornament, as shown ...

If the engine will not start
If the engine will not start even though correct starting procedures are being followed , consider each of the following points: The engine will not start even though the starter motor operates nor ...

Other materials:

Terminals of ecu
1. Inspect integration relay Disconnect the connector from the integration relay. check the continuity between each terminal of the disconnected connector and the body ground, as shown in the illustration and table. Standard: If the result is not as specified, the vehicles si ...

Circuit description
The p squib (2nd step) circuit consists of the airbag sensor assy center and instrument panel passenger airbag assy. It causes the srs to deploy when the srs deployment conditions are satisfied. Dtc b1185/57 is recorded when a short is detected in the p squib (2nd step) circuit. Wiri ...

Using a flat bed truck
If you use chains or cables to tie down your vehicle, the angles shaded in black must be 45. Do not overly tighten the tie downs or the vehicle may be damaged. ■Before emergency towing 1 Vehicles without a smart key system: Put the engine switch in the ACC (engine off) or ON posi ...

2011-2018 Copyright www.tcorolla.net